胀紧夹杆的dosier孔能不能调节圆度
这种夹杆是否是静压膨胀工作原理？胀紧夹杆的dosier孔能不能调节圆度。
使夹杆顶部和底部同心都在0.002毫米以内。
Hydraulic expansion, just like hydraulic milling arbor. joseph8779 发表于 2015-8-18 12:59 static/image/common/back.gif
Hydraulic expansion, just like hydraulic milling arbor.
液压胀形，如液压铣床?
那个dosier孔可以动吗？
Check this out joseph8779 发表于 2015-8-18 15:04 static/image/common/back.gif
Check this out
工作原理清楚了。
但那个孔的作用呢？是不是不能调？
Just like the piston in the hydraulic cylinder, turn the screw in, the pressure increases, if out, the pressure drops.
The hole is like hydraulic cylinder, adjusting the pressure should be through turning in/out the screw. starsea2 发表于 2015-8-18 18:35 static/image/common/back.gif
工作原理清楚了。
但那个孔的作用呢？是不是不能调？
不，那是另外一个螺栓，在顶部。标有德文SPANN-SCHRAUBE.
这个在底部。标为DOSIER-SCHRAUBE.
这个DOSIER孔什么作用？？ joseph8779 发表于 2015-8-19 07:47 static/image/common/back.gif
Just like the piston in the hydraulic cylinder, turn the screw in, the pressure increases, if out, t ...
不，那是另外一个螺栓，在顶部。标有德文SPANN-SCHRAUBE.
这个在底部。标为DOSIER-SCHRAUBE.
这个DOSIER孔什么作用？？
Dosier is dosing in English, to control specified amount of oil input. My understanding is that there should be two holes on your fixture as you mentioned, and this dosing screw is only for filling oil. Also you can use this hole to drain out the oil, but at the same time you need to remove theSPANN-SCHRAUBE, you can figure out why. Normally during production nobody touches the dosing screw. It doesn't help you on roundness. joseph8779 发表于 2015-8-19 15:15 static/image/common/back.gif
Dosier is dosing in English, to control specified amount of oil input. My understanding is that ther ...
thank you.
are you chinese?
页:
[1]
2