|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 编辑
X8 y6 e3 L/ |
7 G0 d1 Q$ [" B- D: L5 X2 L我在做金属切削仿真，在金属切削仿真中采用自适应网格，但是在网格检查时出现自适应不能使用单元畸变控制！！！
, D0 J& e7 I) p3 z1 H9 ^3 @& E( b问题描述如下：
" @: n' A- @7 t3 zAdaptive meshing is not supported for elements used with the distortion control. , q" i; a9 J7 a1 l9 {1 _. U
Domain name: assembly_adapt
w5 S* h& v4 SAbaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.. R& ~5 R9 j! z
: v5 V! `. D) t9 m% |但是不用网格畸变控制吧，又出现了网格畸变问题：! m, s/ \. |! y, n# ?, q6 ]
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
4 g6 o" f- A" D. U8 GThe elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
7 e7 i1 @" _1 g/ J; q" IPrint-out suppressed for subsequent distorted elements9 e5 @5 Y( U3 x: r( c- @
There are a total of 60 excessively distorted elements.7 s' Q- A8 {! b9 Q2 T
请求各位达人帮助，万分感谢！！！/ U3 @0 B) ]( \$ r3 {& K
|
|
发表于 2011-11-30 20:51:21
